Curlin infusion pump manual

Attach the Curlin tubing to the end of your injection cap. Open all clamps; press “Run” to start. If the green light is flashing, the pump is running. At Completion of Infusion: 1. When infusion is completed, the display will say, “Infusion Complete.” Press “Pause,” then “Off”. 2. Close the clamp on tubing. 3.  · The Curlin CMS (Central Management System), is a technologically advanced, multi-therapy ambulatory electronic infusion pump. The Curlin Medical CMS is a unique, technologically advanced, multi-therapy ambulatory electronic infusion pump that continuously monitors and displays Line Pressure to help you detect potential catheter. Infusion Therapy” booklet for additional information. This information is not intended to be a substitute for professional advice. Always do what your doctor, nurse or pharmacist recommends. These instructions are meant to provide you with the basic steps to administer your medication. Please refer to your Curlin Pump manual for.

After connecting the Curlin tubing to the patient, press "Run to Start" and the green light will flash the entire time during the infusion. If your patient wants to be disconnected from the pump briefly, press the "Pause" key. After 5 minutes the alarm will sound if you do not restart the infusion. In recent months, Curlin has seen an increase in the number of pumps involved in over-infusion or free-flow incidents where the pump has been dropped with the door open statements already in the operator's manual, Curlin is making the following modifications to the operator's manual (P/N ). CURLIN MEDICAL Series ™ and Series™* Ambulatory Infusion Pumps Clinician's Guide INTERMITTENT THERAPY REFER TO USER'S MANUAL FOR DETAILED INSTRUCTIONS KEYPAD FUNCTION ON/OFF: Turns pump on and off. When the pump is running, the PAUSE key must be used to stop infusion first. Then press the OFF key to turn pump off.

The Moog Curlin Infusion pump can be carried in any of the four convenient carryall soft-packs, pole mounted, placed into the locked ―safety shells,‖ or set on a suitable surface for use. Delivery Modes The pump features five therapy delivery modes: 1 Continuous Infusion—Designed to allow a constant, programmed rate of infusion. 2. Enter Time infusion should begin (HH:MM), press YES. 3. Enter Date infusion should begin (MM/DD/YY), press YES. 4. Press YES to ACCEPT. CONTINUOUS THERAPY SETTING MEDLMTS 1. At the medLMTS field, press NO to OFF, then press YES to ON. 2. Enter the upper limits of the infusion rate (the range for this field is to mL/hr), then press. Attach administration tubing to pump 1. Put the yellow flow-stop clamp into the square hole under the end of the pump door on the left side. 2. Put the square blue tubing guide into the square hole under the end of the pump door on the right side. 3. Make sure the tubing rests in the notch in front of the pump door on the right. 4.