Canopy surge suppressor user manual

1 FirstSurge™ Surge Protective Device Data Sheet 1 User’s Manual (this document) If the Flush Mount Kit (Part #XMFMKIT) was ordered, additional parts are supplied as follows: 1 Flush Mount Plate 4 Pan-head Screws See Figure 3 for installation Carefully inspect each item in the package for signs of damage. If damage. This provides the best assurance that − lightning takes the ground wire route − the ground wire does not fuse open − your grounding system complies with NEC Ground the Canopy Surge Suppressor SS ground lug to the same ground bonding point as above, using at least a AWG (6 mm) copper wire. Surge Suppressor User Manual Issue 2 Page 5 of 9 PRODUCT DESCRIPTION The Canopy Surge Suppressor has six (6) basic components as shown in Figure 1: 1. Mounting holes— These holes can be used for mounting the Surge Suppressor unit to a flat surface such as an outside wall. The distance between the centers of the holes is inches ( mm). 2.

The surge protector is working properly, but should not be used in an incorrectly wired outlet. • For units with phone line protection, plus the phone line from the wall into the jack that reads "in", and the phone line from the fax or phone into the jack that reads "out". • Plug the equipment to be protected into the surge protector. 1. Remove the Canopy Surge Suppressor cover by removing the screw located on the front of the unit. Page 7: Placement PLACEMENT The following are 2 descriptions of different installation placements, using the Canopy Surge Suppressor in combination with other Canopy products. (Subscriber Module, Cluster Management Module, and BackHaul module). gers, into the surge suppressor or into an outlet on the same circuit. Use only a surge suppressor that meets all of the specifications described on page To purchase a surge suppressor, see your local PROFORM dealer, call the telephone number on the front cover of this manual, or see your local electronics store.

SP - V Surge Protector User Manuals: Driven by the increasing demand for energy efficient lighting, Venture has, since the early s been a pioneer of light source technology. 1. Remove the Canopy Surge Suppressor cover by removing the screw located on the front of the unit. Page 7: Placement PLACEMENT The following are 2 descriptions of different installation placements, using the Canopy Surge Suppressor in combination with other Canopy products. (Subscriber Module, Cluster Management Module, and BackHaul module). Canopy User Guide and local grounding and electri-cal code. It is recommended to install a surge protector (such as the SPSMP or SS) at the base of the installation for complete lightning protection. Foiled shielded twisted pair CAT5 with shielded RJ45 plugs is recommended between the Canopy radio and the GPS over POE device. Required Equipment.