Alco-sensor iii instruction manual

 · Alco-Sensor. III. Rated out of 5 based on 1 customer rating. (1 customer review) Widely used, the Alco-Sensor III (ASIII) is a pocket-sized, handheld breath alcohol tester. This NHTSA approved Evidential Breath Alcohol Testing Device provides a simple, accurate and economical method of determining a subject’s breath alcohol concentration.5/5(1). The Alco-Sensor III assists education administrators and campus security in monitoring and preventing alcohol abuse during school hours, sporting events, dances, and social events. Product Document Library. Alco-Sensor FST. Datasheet - Law Enforcement Version. Datasheet - Rehab Version. Illustrated Accuracy Check. Illustrated Calibration Procedure. Calibration Document. Alco-Sensor III. Datasheet - Law Enforcement Version.

The Alco-Sensor IV, a widely used hand held breath tester that is unheated and has no flushing pump was used to investigate the possibility of carry over. The Alco-Sensor IV is designed to automatically capture a small portion of deep lung air as the breath passes through the instrument and deliver it to the fuel-cell sensor for measurement. Instruction Manual. TABLE OF CONTENTS sensor. P. 5 OPERATING INSTRUCTIONS Pre-test Conditions 1. Operating temperature range is °C to 50°C. Use within this temperature iii. Longitude and Latitude of the test is stored and printed on the printout. iv. Select "Print GPS" so GPS result will be printed on the printout. Operating Instructions Wait 20 minutes after the subject smokes, eats or drinks before testing. Failure to wait 20 minutes can give inaccurate BAC read-ings and harm the sensor. Step 1) Insert a NEW MOUTHPIECE each time you perform a test. Step 2) If it has been more than 24 hours since the device was last.

3. Only the Alco-Sensor III PBT instrument is approved in the Washington Administrative Code. If your agency uses a different PBT instrument you must contact the State Toxicology Laboratory to determine its acceptability for use. B. Steps of operation 1. Check the temperature display - should be C 2. Push the "Set" button 3. Manual THE INSTRUMENT The Alco-Sensor III is a pocket-sized, handheld breath alcohol tester. It provides a simple, accurate and economical method of determining a subject’s breath alcohol concentration with evidential grade accuracy. UNIQUE FEATURES The Alco-Sensor III offers last test recall, mouthpiece ejector, internal temperature sensor. 6) Attach new dry mouthpiece to Alco-Sensor III. 7) Attach Alco-Sensor III mouthpiece to the calibration device gas out port. (Make certain there is a good seal between the connector and the mouthpiece). 8) If you are using a dry gas standard, depress the button on the regulator for 6 seconds.